FVS Component Basic Attributes

Applicable scenarios: Users who have installed the "FVS Large Screen Editing Mode" plugin can refer to this article to learn about the related functions of the FVS template.

1. Version

2. Function introduction

This article will briefly introduce the component name, size, location and other settings. As shown below:

Note: Please refer to FVS Page Background & Component Background for component border background.

Users can modify the component name by themselves, as shown in the following figure:

• When a component is newly created, it will be given an initial name by default. The rule for the initial name is "page name + component type + n", such as "Page 1_Pie chart1"

• Component name cannot be empty.

• Components on the same page cannot have the same name. Components with the same name are supported on different pages on the same canvas.

• When a component is copied and pasted, if there is a component with the same name on the current page, the pasted component will automatically modify the name, and automatically add the name suffix "_c". If the current page does not have a component with the same name, the pasted component will keep the original name.

The width and height of the component, the unit is px.

• There are two ways to modify the size of the component: you can enter the specified value in the configuration bar, or you can manually drag and drop on the canvas to adjust the size.

• When setting the component size, you can lock the component aspect ratio in the configuration bar to prevent the component from deforming. Disabled by default.

• Changes in canvas size do not affect component size.

The component position refers to the horizontal and vertical distance between the upper left corner of the component and the upper left corner of the page. As shown below:

Component padding refers to the space between the component border and the component content.

You can set the top, bottom, left, and right padding of the component, as shown in the following figure:

The rotation angles in the x, y, and z axis directions can be set separately. The angle adjustment range is 0～360, the default is 0.

The visibility distance of the component can be set. The setting range is a positive value, and the default is 500.

If the 3D rotation is set for a single component, the corresponding rotation center is the center of the component.

If the 3D rotation is set for a group component, the corresponding rotation center is the center of the group.

If multiple sets are nested in groups, the rotation center of the component setting is the center of the previous group, regardless of the situation of the upper level.

The overall opacity of the component, the setting range is 0~100. Defaults to 100.