Superscript and Subscript

When making a report, you need to input units more or less, such as: ㎡, ℃, which can be directly input in a cell of the report. 

1. Rich text

Insert rich text into the cell, as shown in the following figure:

2. When only one cell is required to enter the unit

As above, all the input units can be directly edited by the input method, Just units that can be directly copied from other places can be directly placed in a cell to display this unit.

3. When two cells are required to enter the unit

For units with uncertain subscripts and subscripts, you need to use two cells to realize the input unit. like:,, first enter the content in the two cells respectively, then select the cell where the subscript content needs to be set, select the cell, and select on the rightCell Properties > Style > Text, font selection superscript or subscript, and finally you can adjust the alignment of the cells to achieve the desired effect. like:, here is to set the A1 cell to the right alignment, and you can see the style displayed as a unit in the final preview.

Note: If some units are placed in the cell, the page preview cannot be displayed normally, you can select the cell, select Others in the cell property panel on the right, and select Display content with pictures.