Initial Configuration

After deploying and starting FineDataLink, you can access http://IP address:Port number/Project name/decision to enter the configuration page of the decision-making system.

This document describes steps for first-time access to FineDataLink and subsequent logins.

Note:

Initial configuration is required only upon first-time access to the decision-making system. For future access, you will directly enter the login page.

After installing and starting FineDataLink locally, enter the address http://IP address:Port number/Project name/decision in a browser to access FineDataLink. You will be redirected to a guide page, on which you need to configure Account Setting and Database sequentially, as shown in the following figure.

The default address is http://localhost:8068/webroot/decision.

Account Setting

You need to set up a super admin, who holds the highest level of permission in FineDataLink and manages the entire system, including users, data, permission, and system information.

Enter a username and a password for the super admin and click Next. The account is set successfully, as shown in the following figure.

Note: 

Make sure that you remember the username and the password. Do not forget the super admin password as it cannot be modified or reset!

Note: 

In case you forget your password, refer to Admin Modifying/Resetting Password to reset it.

Database Selection

The FineDB database stores all the platform configuration information of FineDataLink projects, including pipeline tasks, scheduled tasks, permission control, and system management. For details, see FineDB Database Introduction

Click Next to enter the database selection page, as shown in the following figure.

Built-in Database

The built-in database is suitable for individual local trials. You can click Direct Login and log in to the system to use it.

External Database

The external database is suitable for official enterprise use. You can click Configure Database and set up the external database.

If you (as the admin) have selected the built-in database during the initial configuration but later want to switch to an external database, see External Database Configuration

Login

Enter your username and password, and click Login to access the system, as shown in the following figure.

Start FineDataLink, access http://IP address:Port number/Project name/decision to enter the login page, enter the correct username and password, and click Login, as shown in the following figure.

The default address is http://localhost:8068/webroot/decision.

Note: 

For details about modifying the FineDataLink access port, see Modifying the Tomcat Port Number